Internal MV circuits: Difference between revisions
From Electrical Installation Guide
(Text updated (guide 2015)) |
(Text modified (guide 2015)) |
||
| Line 9: | Line 9: | ||
'''Fig. D11:''' Single feeder, Dual feeder, Open ring | '''''Fig. D11:''''' ''Single feeder, Dual feeder, Open ring'' | ||
Comparison of these three typical principles of internal distribution is given '''Fig D12.''' | Comparison of these three typical principles of internal distribution is given '''Fig D12.''' | ||
| Line 39: | Line 39: | ||
|} | |} | ||
'''Fig. D12:''' Comparison of the typical internal circuits | '''''Fig. D12:''''' ''Comparison of the typical internal circuits'' | ||
[[ru:Конфигурация схемы высокого напряжения]] | [[ru:Конфигурация схемы высокого напряжения]] | ||
[[zh:中压回路的配置]] | [[zh:中压回路的配置]] | ||
Revision as of 10:38, 8 December 2014
Internal MV circuits are dedicated to the supply of the secondary MV/LV substations dispersed in the installation. They are three typical principles commonly used for this purpose (Fig. D11):
- Single feeder
- Dual feeder
- Open ring
Fig. D11: Single feeder, Dual feeder, Open ring
Comparison of these three typical principles of internal distribution is given Fig D12.
| MV circuit configuration | |||
|---|---|---|---|
| Characteristic to consider | Single feeder | Open ring | Dual feeder |
| Site topology | Any | Single or several buildings | Single or several buildings |
| Power demand | Any | > 1250kVA | > 2500kVA |
| Disturbance sensitivity | Long interruption acceptable | Short interruption acceptable | Short interruption not acceptable |
Fig. D12: Comparison of the typical internal circuits
