|
|
| (7 intermediate revisions by 2 users not shown) |
| Line 1: |
Line 1: |
| <div class="noprint"> | | <includeonly> |
| <div class="template_div"> | | <!---------- modify the chapter letter below, to adapt to each chapter ----------> |
| {| class="template_table" | | {{#vardefine:letter|G}} |
| | | [[General rules of electrical installation design]]
| | <!----------------------------------------------------------------------------------------------------> |
| |-
| | {{#isin:{{#hierarchyParent:{{#titleparts:{{FULLPAGENAME}}}}|{{MediaWiki:eig-hierarchy}}|hierarchyargtype=wikitext|link=none}}}} |
| | | [[Connection to the MV utility distribution network]]
| | {{#set:Has chapter letter={{#var:letter}}}} |
| |-
| | {{#vardefine:menuMsg|eig-ch-menu-{{#var:letter}}}} |
| | | [[Connection to the LV utility distribution network]]
| | {{#sideSummary:{{#var:menuMsg}}}} |
| |-
| | {{ch-category|{{#var:letter}}}}[[Category:eig-content-pages]]</includeonly><noinclude>[[Category:eig-ch-menus]]<templatedata> |
| | | [[MV and LV architecture selection guide for buildings]]
| | { |
| |-
| | "params": {}, |
| | | [[LV Distribution]]
| | "description": "This template is used to add common information to pages of a same chapter: semantic property for parent page, chapter category, and sidemenu" |
| |-
| | } |
| | | [[Protection against electric shocks and electrical fires]]
| | </templatedata> |
| |-
| | </noinclude> |
| | id="chapter" | [[Sizing and protection of conductors]]
| |
| |-
| |
| | class="selected" |
| |
| * [[Conductor sizing and protection]]
| |
| ** [[Conductor sizing: methodology and definition]]
| |
| ** [[Overcurrent protection principles]]
| |
| ** [[Practical values for a protective scheme]]
| |
| ** [[Location of protective devices]]
| |
| ** [[Conductors in parallel]]
| |
| * [[Practical method for determining the smallest allowable cross-sectional area of circuit conductors]]
| |
| ** [[General method for cable sizing]]
| |
| ** [[Recommended simplified approach for cable sizing]]
| |
| ** [[Sizing of busbar trunking systems (busways)]]
| |
| * [[Determination of voltage drop]]
| |
| ** [[Maximum voltage drop limit]]
| |
| ** [[Calculation of voltage drop in steady load conditions]]
| |
| * [[Short-circuit current]]
| |
| ** [[Short-circuit current at the secondary terminals of a MV/LV distribution transformer]]
| |
| ** [[3-phase short-circuit current (Isc) at any point within a LV installation]]
| |
| ** [[Isc at the receiving end of a feeder as a function of the Isc at its sending end]]
| |
| ** [[Short-circuit current supplied by a generator or an inverter]]
| |
| * [[Particular cases of short-circuit current]]
| |
| ** [[Calculation of minimum levels of short-circuit current]]
| |
| ** [[Verification of the withstand capabilities of cables under short-circuit conditions]]
| |
| * [[Protective earthing conductor (PE)]]
| |
| ** [[Connection and choice for protective earthing conductor]]
| |
| ** [[Sizing of protective earthing conductor]]
| |
| ** [[Protective conductor between MV/LV transformer and the Main Low Voltage Switchboard (MLVS)]]
| |
| ** [[Equipotential conductor]]
| |
| * [[The neutral conductor]]
| |
| ** [[Sizing the neutral conductor]]
| |
| ** [[Protection of the neutral conductor]]
| |
| ** [[Breaking of the neutral conductor]]
| |
| ** [[Isolation of the neutral conductor]]
| |
| * [[Worked example of cable calculation]]
| |
| |- | |
| | | [[LV switchgear: functions and selection]] | |
| |- | |
| | | [[Overvoltage protection]]
| |
| |-
| |
| | | [[Energy Efficiency in electrical distribution]]
| |
| |-
| |
| | | [[Power Factor Correction]]
| |
| |-
| |
| | | [[Power harmonics management]]
| |
| |-
| |
| | | [[Characteristics of particular sources and loads]]
| |
| |-
| |
| | | [[PhotoVoltaic (PV) installation]]
| |
| |-
| |
| | | [[Residential and other special locations]]
| |
| |-
| |
| | | [[ElectroMagnetic Compatibility (EMC)]]
| |
| |-
| |
| | | [[Measurement]]
| |
| |-
| |
| |-
| |
| |}
| |
| </div> | |
| [[Category:Chapter - Sizing and protection of conductors]]
| |
| </div> | |
