Location of protective devices

A protective device is, in general, required at the origin of each circuit

General rule

(see  Fig. G7a)
A protective device is necessary at the origin of each circuit where a reduction of permissible maximum current level occurs.

Possible alternative locations in certain circumstances

(see  Fig. G7b)
The protective device may be placed part way along the circuit:

• If AB is not in proximity to combustible material, and
• If no socket-outlets or branch connections are taken from AB

Three cases may be useful in practice:

• Consider case (1) in the diagram

- AB ≤ 3 metres, and

- AB has been installed to reduce to a practical minimum the risk of a short-circuit (wires in heavy steel conduit for example)

• Consider case (2)

- The upstream device P1 protects the length AB against short-circuits in accordance

• Consider case (3)

- The overload device (S) is located adjacent to the load. This arrangement is convenient for motor circuits. The device (S) constitutes the control (start/stop) and overload protection of the motor while (SC) is: either a circuit-breaker (designed for motor protection) or fuses type aM

- The short-circuit protection (SC) located at the origin of the circuit conforms with the principles

Circuits with no protection

(see Fig. G7c)
Either

• The protective device P1 is calibrated to protect the cable S2 against overloads and short-circuits

Or

• Where the breaking of a circuit constitutes a risk, e.g.

- Excitation circuits of rotating machines

- circuits of large lifting electromagnets

- the secondary circuits of current transformers

No circuit interruption can be tolerated, and the protection of the cabling is of secondary importance.

---

   [a]

---

   [b]

---

   [c]

---

Fig. G7: Location of protective devices