LED lamps - choice of contactors

Figure N49 and Figure N50 show the maximum number of LED lamps for each contactor / relay.

• These values are given for a 230 V circuit with 2 active conductors (single-phase phase/neutral or two-phase phase/phase). For 110 V circuits, divide the values in the table by 2.
• To obtain the equivalent values for the whole of a 230 V three-phase circuit, multiply the number of lamps and the total acceptable power:
  • by √3 (1.73) for circuits with 230 V between phases without neutral,
  • by 3 for circuits with 230 V between phase and neutral or 400 V between phases.
• for Reflex iC60:
  • B-curve ratings, the number of lamps should be reduced by 50 %.
  • D-curve ratings, the number of lamps should be increased by 50 %.

Products			iCT contactors								iCT+ contactors
Type of lamp			Maximum number of light fittings for a single-phase circuit and maximum power output per circuit
			16 A		25 A		40 A		63 A		20 A
LED lamps
With driver	10 W		48	500 W to 1400 W	69	700 W to 1950 W	98	1000 W to 3000 W	200	2000 W to 6200 W	4660 W x cos φ
	30 W		38		54		77		157
	50 W		27		39		56		114
	75 W		17		25		36		73
	150 W		9		12		18		37
	200 W		7		9		15		31

Fig. N49 – Maximum number of LED lamps for iCT and iCT+ contactors

Products			iTL impulse relays				iTL+ impulse relays	Reflex iC60 (C curve)
Type of lamp			Maximum number of light fittings for a single-phase circuit and maximum power output per circuit
			16 A		32 A		16 A	10 A		16 A		25 A		40 A		63 A
LED lamps
With driver	10W		69	700W to 1950W	98	1000W to 3000W	3680W x cosφ	30	300W to 850W	44	450W to 1250W	71	700W to 2000W	108	1050W to 3050W	146	1450W to 4150W
	30W		54		77			24		34		55		83		113
	50W		39		56			17		25		40		61		83
	75W		25		36			11		15		24		37		50
	150W		12		18			5		7		11		17		23
	200W		9		15			-		6		10		15		20

Fig. N50 – Maximum number of LED lamps for iTL and iTL+ impulse relays, and for Reflex iC60 (C-Curve)